Basement apartments and In-law suites , Whats legal ?

 Basement apartments  play an important role in meeting demand for housing throughout the Kawartha Lakes area and if you have ever purchased a property with one, you're probably familiar with the "Seller does not warrant retrofit" clause. Second suites can cause confusion for homebuyers and REALTORS alike, but this doesn't have to be the case.

According to noted home inspectors Carson Dunlop, achieving a "legal" basement apartment involves five areas of consideration: bylaw permissibility; compliance with the building, fire, and electrical safety codes; and registration. In short, if a listing indicates that a property has a retrofit basement apartment, it must meet municipal bylaw requirements, have a Certificate of Compliance to verify that it has passed fire and electrical inspections, and be registered with Municipal Property Standards. Additionally, if it is newly constructed, it must meet Building Code requirements.

Identifying whether a municipality's bylaws permit basement apartments and if any special conditions apply is the first step in the process. Since 1995, municipalities have had the authority to enforce their bylaws with respect to basement apartments; however, units that existed prior to November 1995 are exempt from meeting local bylaw requirements.

The Building and Fire Codes are related in that the Fire Code is a subset of the Building Code. There is, however, an important distinction between them. The Building Code, which prescribes minimum requirements for the construction of buildings, for the most part applies only to the day the house was built, not retroactively. The Fire Code, which prescribes construction and safety issues related to how a building is required to perform should it catch fire, does apply retroactively. In 1994, the provincial government set new Fire Code rules with which all basement apartments, new and existing, must comply. A unit upgraded to comply with the Fire Code is called a "basement retrofit". The fire department must inspect all basement apartments, and when any deficiencies have been corrected, as is required, it will issue a certificate to verify compliance.

The Fire Code involves four key areas of compliance: fire containment, means of egress, fire detection and alarms, and electrical safety.

Fire containment refers to a building's ability to contain a fire in the unit where it started. Walls, floors, ceilings and doors are rated based on how long they will survive a direct fire before burning through. The typical requirement is a rating that affords a 30-minute separation between the units. Drywall and plaster ceilings for example, are acceptable but they must be continuous so that joists are not exposed in any room. By contrast, suspended ceilings are not acceptable.

Means of egress refers to the occupants' ability to exit the house. Ideally, units should have their own exits. Units that share a common exit are allowed if the common exit is 'fire separated' from both of the units with a 30-minute rating. If it is not rated as such, it can still be used provided that there is a second exit from each unit and the fire alarms are interconnected. To be considered an acceptable second exit, a window must have an opening of at least 600 square inches, with the smallest dimension being 18 inches; the windowsill must be within three feet of grade; and basement window wells must extend three feet out from the house wall, to allow room to crawl out.

The fire detection area of compliance requires that all units have smoke alarms. Smoke alarms do not have to be interconnected unless the fire separation to the common exit area does not have a 30-minute rating. Some municipalities may also require carbon monoxide detectors.

Electrical safety refers to the required inspection by the Electrical Safety Authority. As with the fire department's inspection, deficiencies that the Electrical Safety Authority identifies must be addressed. In general, an apartment's minimum ceiling height must be 6 feet 5 inches; its entrance door must be at least 32 inches by 78 inches; bathrooms require either a window or an exhaust fan; and if there is a parking spot for one of the units, there must also be a parking spot for the other unit.

Once bylaw and code requirements have been met and certified, homeowners can register the basement apartment with Municipal Property Standards.

Bear in mind that if your clients are planning to construct a basement apartment they must also apply for a building permit and comply with today's Building Code.

For more information on basement apartments contact your municipality

There are no comments

Thank you! Your comment has been submitted and is awaiting approval.

Blog Archives